.
.
Re-drilling ATV wheels can be a useful skill to have, especially if you want to change the bolt pattern or fit different tires on your ATV.
It may seem like a daunting task, but with the right tools and a little bit of patience, you can successfully re-drill your ATV wheels.
In this guide, we will walk you through the step-by-step process of re-drilling ATV wheels.
Tools and Materials
Before you begin, make sure you have the following tools and materials:
- Drill press
- Drill bits
- Center punch
- Measuring tape
- Clamps
- Marker
- Ruler or straight edge
- Shop vacuum or compressed air
Step 1: Preparation
Start by cleaning the ATV wheels thoroughly.
Use a shop vacuum or compressed air to remove any dirt, debris, or metal shavings from the previous drilling.
This will ensure a clean and precise re-drilling process.
Step 2: Determine the New Bolt Pattern
Decide on the new bolt pattern for your ATV wheels.
This will depend on the specific requirements of your ATV and the tires you want to fit.
Measure the distance between the bolt holes using a measuring tape, and make a note of the measurements.
Step 3: Mark the New Hole Locations
Using a marker, mark the new hole locations on the ATV wheels.
Make sure to double-check your measurements and ensure that the new holes are evenly spaced and aligned correctly.
You can use a ruler or straight edge to help you make accurate markings.
Step 4: Center Punch the Markings
Using a center punch, create a small indentation at each marked location.
This will help guide the drill bit and prevent it from slipping when you start drilling.
Step 5: Secure the ATV Wheel
Place the ATV wheel on a stable surface or secure it in a vice.
Make sure it is firmly held in place to prevent any movement during the drilling process.
You can use clamps to secure the wheel if needed.
Step 6: Start Drilling
Put on your safety glasses to protect your eyes from any flying debris.
Set up your drill press with the appropriate drill bit for the new hole size.
Start drilling slowly and steadily, applying even pressure.
Take breaks if necessary to prevent overheating of the drill bit.
Step 7: Clean and Deburr
Once you have drilled all the new holes, use a shop vacuum or compressed air to remove any metal shavings or debris from the drilled holes.
This will ensure a clean and smooth finish.
Use a deburring tool or a file to remove any sharp edges or burrs around the new holes.
Step 8: Test Fit and Finalize
Before mounting the ATV wheels back on your ATV, do a test fit to ensure that the new bolt pattern aligns correctly with the ATV hub.
If everything looks good, you can finalize the re-drilling process by mounting the wheels back on your ATV.
Conclusion
Re-drilling ATV wheels may seem like a challenging task, but with the right tools and proper guidance, you can successfully change the bolt pattern or fit different tires on your ATV.
Remember to take your time, double-check your measurements, and always prioritize safety.
Happy re-drilling!
